Mounted my Jardine differently, see pics

[n2bikes]

So I decided to mount my exhaust a little different. I didn't want to have the strap seen so i rivited it to the top after cutting it. I also put some dynamat under the seat area for the heat. Check out the pics.

[Repsoul]

Pretty sweet Thomas.......:thumbsup:

Looks good and I like the idea with the riveting over a strap. Just wondering how the vib's will do. With the strap the load is on the bottom of the pipe where as the riveting the load is up top. Hmmmmmmmm:confused2:

All in all, I think it almost gives it a free floating look. Again, pretty cool.

[n2bikes]

I was also not sure about the rivet on top but that's why I used 3 each side. The exhaust is not too heavy so I'm sure it'll be ok.

[Repsoul]

I was also not sure about the rivet on top but that's why I used 3 each side. The exhaust is not too heavy so I'm sure it'll be ok.

Sounds good dude. :D;)

[rsxscrazy]

looks good. I do like yeah 3 rivits per side should hold good.

[usnavynuke]

Good idea, i think i'm go do the same.

[fredie]

:applause::hail:very good work:D

[Tripage]

Did this to my two brothers, had it like this for 2 years now. No problems. Looks good. T

[cowboyadam]

That looks good. Kinda different but cool.

[Aussierepso7]

Looks good no doubt about it.. I would be worried about the carbon letting go but!