tacking apart the back end

[wickedwrestler]

I am new to this site. i just bought a 07 repsol last week and wanted to take the back piece off that holds the licesne plate. Was just wondering how hard it it? should i just have the dealer ship do it? get back to me thanks.

[highside]

Its not hard, just keep in mind that the rear cowl will bend more than it looks like it will. But its not hard.

[Thrasher]

Its very easy I just installed the CW fender eliminator kit and followed the instructions. As I remember you remove the seats front seat has 5mm allen heads at rear corners then remove the rear fairing 4 5mm allen heads two on side and two under back seat, then very carfully wiggle pry off the rear fairing. Then I think there were 3 bolts/screws on each side holding the back assembly on. Just be carefull I'm not sure I remember everything. If you buy the competition works fender eliminator the instructions are pretty easy. Check it out and listen to what the other guys say. lots of good advice here.:)

[wickedwrestler]

ok thanks. what are some good site to order parts from? Im looking to get exhaust frame sliders etc.

[highside]

Go to

http://www.hardracing.com/

give them a try.

[Big Kahuna]

Check out http://www.fresnomotorsports.com. They are still building their site but give them a call for pricing on anything you want. they've got an awesome deal on Pazzo right now with their instant rebate going on now. :)

[silvercbr]

I was so tempted to document putting my exhaust on, step by step, and put it in a powerpoint for the site. Maybe if someone hasn't put their exhaust on yet, they could do something similar. I did it when my wife was out of town at her family's house, and she took the digital camera.