2007 Flush Mount Front Signals

[TX Repsol]

I just installed the Lockhart Phillips flush mount front signals, part number 122-6017.

For the most part, I'm very pleased. Install was painfully simple. Simply remove the middle fairing, take one bolt loose from the stock blinker, clean adhesion surfaces with rubbing alcohol, and insert blinkers into the fairing hole with provided double-stick tape.

My one and only complaint is that one of the LED plates inside the blinker came loose during the install. It still works, but the bulbs are sort of floating around inside. I don't see any real issue with it so I went ahead and installed it.

Here are before and after shots for those interested. I'll try and get some better "after" shots - it was dark when I took these. Still good enough for a comparison though.

Stock Front - http://i21.photobucket.com/albums/b265/hardwickcj/FrontStock.jpg

Flush Front - http://i21.photobucket.com/albums/b265/hardwickcj/FrontFlush.jpg

Stock Left - http://i21.photobucket.com/albums/b265/hardwickcj/LeftStock.jpg

Flush Left - http://i21.photobucket.com/albums/b265/hardwickcj/LeftFlush.jpg

[TX Repsol]

OK - my first real post and I posted in the wrong sub-forum... :o

I posted a new thread in the correct forum - will a mod/admin delete this thread for me?

Thanks.